AFC series products is a clear rubber coating based on polydimethylsiloxane technology. It offers an anti-fouling effect to the boat hull and running gear while offering enhanced cruising range and ship speed through reduced friction of the hull through the water.
1Kg can & 1Gallon can
Curing Cure speed can be accelerated with increased humidity and heat to very rapid cure times.When cured, this product will still feel wet to the touch. The oily residue on the surface is what makes this product effective, and will continue to feel this way throughout the service life Typical utilization involves spraying or painting on in open air exposure to ambient humidity at room temperature. Cures within 48 hour.
AFC series reacts with moisture in the air and begins to cure at the surface. Con-sequently, the cure speed will vary according to the temperature and humidity of the use environment. In addition, please note that if humidity exceeds 100% and water droplets form on the curing rubber, a hydrolytic reaction will precede the crosslinking cure reaction, which will reduce the strength of the post-cured rubber and remain surface tackiness.
Does not use AFC series products condensation cure products in a completely en-closed space. AFC series products may yellow over time, but this does not negatively affect the characteristic properties. Completely remove water, oil, dirt, and contaminants from the surface of the adherend. For certain
substrates, use a primer as needed.
When using an air gun, do not exceed 0.3MPa.
Using sandpaper or a solvent (toluene, xylene, etc), thoroughly clean the surface to remove all foreign matter such as rust, oil, dirt, and grime that may impair bonding. Use caution when cleaning plastics with solvents, as some solvents may damage certain plastics.
Application of primer
Apply uniformly using a brush or other tool. Be careful that no spots are missed, as there may be
poor adhesion in those areas. Storage precaution
Stored between 1~30C, out of direct sunlight.
Sealed containers are guaranteed for 12 months from the ship date when stored in a cool dry area below 70°F.
Be sure to provide adequate ventilation. If you experience any unpleasant symp-toms please move to an area with fresh air.
Uncured AFC series products may irritate skin and mucous membranes, so avoid eye contact and prolonged skin contact. In case of accidental eye contact, flush with water for at least 15 minutes and see a physician. In case of skin contact, im-mediately wipe off with a dry cloth and wash with soapy water. Contact lens wearers should exercise adequate caution; if uncured AFC series products enters the eyes, the contact lens may become bonded to the eye.
When using, be careful not to rub the eyes with the hands. Please take appropriate precautions such as wearing safety glasses.
Make sure that work area is well ventilated. Be careful not to inhale vapors from the products used.
Keep out of reach of children.
For more information, please read the Material Safety Data Sheet (MSDS).
All recommendations, statements and technical data herein are based on tests we believe to be reliable and correct, but accuracy and completeness of said tests are not guaranteed and are not to be construed as warranty, either expressed or applied.
User shall rely on his/her own information and tests to determine suitability of the product for the intended use, and the user assumes all risk and liability resulting from the use of this product. Manufacturer’s sole responsibility shall be to replace that portion of product that the manufacturer proves to be defective.
Manufacturer shall not be liable to the buyer or any third party for injury, loss or damage directly or indirectly resulting from the use of, or inability to use, the product.
Recommendations or statements other than those contained in a written agreement signed by an officer of the manufacturer shall not be binding by the manufacturer.
This product has not been tested for, and is therefore not recommended for, uses for which prolonged contact with mucous membranes, abraded skin, or blood is intended; or for uses which implantation within the human body is intended.
※Professional series - AFC-P400 :
中文
